Definition of wall paving panels and their reasonable installation methods

- Oct 19, 2018 -

The definition of Wall Decoration Panel and its reasonable installation method Wall-surfacing panel is a kind of decorative panel based on wood, which is being widely used in the home decoration of new wall decoration materials, we can use it to replace the wall brick, Wallpaper and other decorative wall materials, it is light and convenient, very safe to use, and decoration effect is also quite good, often people will also apply it to some particularly luxurious family decoration. Before preparing for the construction of the wall surfacing panel, the length and width of the wall surface should be measured first. According to the size of the parapet board, the integral block of the wall board needed to be finished decoration should be calculated, and the waste of materials should be reduced as much as possible. If there is extra space to use the parapet board to complete, the location of the splice is best assigned at both ends, so as not to affect the overall effect. At the same time, the wall should be kept clean, dry and smooth, and the height of the elastic line should be leveled. In order to adapt to the local climatic conditions, the wall paving panel should achieve the moisture content of the air. Then, the hooks of the kick wire should be fixed to the wall with expansion screws or steel nails. The height from the ground should be 7. 8 cm, with a hook fixed every 60cm interval, and then the 45 °kick line should be attached to the hook. When installing the wall surfacing panel, insert it into the kick line from left to right. The first piece is best fitted from the groove to the corner of the wall. The expansion screw or steel nail should be installed at the 1.5cm from the upper mouth of the parapet. Be sure that the screw does not expose the wall plate. This affects the appearance. When installing the wall surfacing panel to the end, the two edges of the corner need to be coated with special glue, sticking to the top corner, then pulling back for a while and then sticking tightly to it. This increases the fastness of the wall coverings and their service life.http://www.wpc4flooring.com/